- Engine protection from the bottom
- front exhaust pipe
- Air duct and air cleaner housing
- Intercooler
- engine cover
- valve cover
- Vacuum pump
- Rear cylinder head cover assembly
- High pressure fuel lines
- Fuel drain tube and fuel injector assy
- Secondary timing chain with related parts
2. Remove the camshaft sprockets.
Loosen the camshaft sprocket set bolt while holding the camshaft by the hex portion with a 21mm wrench.
3. Remove camshafts.
Loosen the set screws in the reverse order of the figure shown in several steps and remove them.
4. Remove adjusting washers and pushers of valves.
Remember the installation locations of the parts and store them so as not to confuse them.