Table of contents: Right oil seal (front cover seal) ↓ Rear oil seal (flywheel seal) ↓
Right oil seal (front cover seal)
1. Remove the crankshaft pulley.
2. Carefully remove the seal by prying it up with a screwdriver.
3. Clean the seal housing and remove all burrs and sharp edges.
4. Lubricate and carefully press the new seal until it stops in the flange provided on the outer surface.
5. Remove any remaining grease, then install the crankshaft pulley.
Rear oil seal (flywheel seal)
1. Remove the flywheel (see subsection 3.1.1.15).
2. Pry the oil seal up and carefully remove it from the cylinder block.
3. Clean the seal housing.
4. Lubricate the working edges of the new oil seal and the sealing journal of the crankshaft with a thin layer of consistent grease, correctly orient the oil seal relative to the crankshaft housing.
5. Carefully place the oil seal on the crankshaft and press it in without distorting it so that the surface of the oil seal is flush with the flange on the cylinder block.
(The article was obtained from the portal: www.NISSANBOOK.ru)
6. Remove any remaining grease and install the flywheel.