Removal
1. On 1.6L models, remove the air cleaner housing (see subsection 6.3.2.2) to improve access to the end of the cable connected to the throttle body.
2. Disconnect the cable from the cam on the throttle body.
3. Loosen the nuts securing the cable sheath to the bracket and remove the cable sheath from the bracket.
4. Release the cable along the entire laying route.
5. In the passenger compartment, remove the lower panel on the driver's side.
6. Disconnect the cable from the pedal.
7. Loosen the nuts securing the casing to the engine compartment bulkhead and remove the cable, pulling it into the engine compartment.
Installation
1. Route the cable through the engine compartment bulkhead.
2. Pull the cable into the engine compartment and place it in place.
3. Secure the cable sheath to the engine compartment bulkhead with nuts.
4. Attach the cable to the pedal.
5. Install the bottom panel.
6. Secure the cable sheath along the entire route.
7. Attach the cable to the cam on the throttle shaft.
8. Adjust the cable. On Phase II models with a 2.0L engine, the throttle valve is controlled via an intermediate cam that is mounted on top of the intake manifold. Then adjust the throttle valve cam setting.
Throttle Cam Adjustment
1. Loosen the lock nut and remove the intermediate cam limit screw.
2. While holding the cam in the fully open throttle position, tighten the screw until it touches the limiter lever. Then, release the cam and turn the screw three full turns clockwise. While holding the screw, tighten the lock nut.
3. Move the cam to the fully open throttle position and check that the cam stop lever contacts the screw.