General information
Brake system | With double diagonal contour separation, front disc (with single piston calipers) and rear drum brakes |
Type of brake fluid | FMVSS 116 DOT 4 or DOT 3 (do not mix DOT 4 and DOT 3 fluids) |
Parking brake lever travel | |
| 11÷12 clicks |
| 15 clicks |
GTZ diameter, mm | 23.81 |
Released brake pedal height (models with manual transmission // AT), mm | 161÷171 // 171÷181 |
The height of the brake pedal, squeezed out with the engine running with a force of 490 N (models with manual transmission // AT), mm, not less than | 80 // 85 |
Gap between the rubber stopper of the pedal and the end of the D / B brake lights, mm | 0.74÷1.96 |
Free travel of the brake pedal, mm | 3÷11 |
Permissible vacuum loss at the control valve (from -66.7 kPa), kPa | up to 1.3 in 15 seconds |
Front wheel brakes
Type | CL22, disc, ventilated |
Nominal // minimum permissible thickness of brake discs, mm | 22 // 20 |
Nominal // minimum allowable brake pad lining thickness (without backing), mm | 12.4 // 2.0 |
Brake disc outer diameter, mm | 260 |
Maximum admissible unevenness of a brake disk, mm | 0.03 |
The maximum allowable runout of the brake disc installed on the car, mm | 0.058 |
Piston diameter, mm | 53.95 |
Rear wheel brakes
Type | LT20 drums |
Nominal // maximum allowable inner diameter of the brake drum, mm | 202 // 203.2 |
Nominal // minimum allowable brake pad lining thickness (without backing), mm | 4.5 // 1.5 |
Length // brake lining width, mm | 195 // 38 |
Brake cylinder diameter, mm | 19.05 |
Vacuum booster
Type | E52 / 5 / 255 |
Aperture diameter, mm | 254 |
Input rod installation size, mm | 158.25 |
Permissible vacuum loss (from -66.7 kPa), kPa | up to 3.3 in 15 seconds |
Tightening force of threaded connections, Nm
Brake hoses to caliper | 18 |
Fasteners for brake pipes | 16.2 |
Nuts of fastening of assembly of pedals | 21 |
Anchor bracket bolts | 105 |
Bolts of fastening of supports to an anchor bracket | 35 |
bleed valve | 10 |
Brake Disc Mount | 13.9 |
Bolts of fastening of back wheel cylinders | 9 |
Fixture of assembly of the lever of a parking brake | 21.5 |
Fixture of brackets of cables of a parking brake | 5.3 |
Fasteners for wheel sensors | 21.6 |
Bolts for fastening the activator bracket and the ABS control unit | 12.8 |
Bolts for fastening the activator and the ABS control unit to the bracket | 8 |