Removal
1. Disconnect the connector.
2. Loosen the mounting bolts and remove the accelerator pedal assembly.
Attention:
- Do not disassemble the accelerator pedal assembly or remove the sensors.
- When performing operations, avoid impacts due to falls, etc.
- Do not allow water to come into contact with the pedal.
Installation
Installation is carried out in the reverse order of removal, taking into account the following:
Insert the lock pin from the vehicle side and fix the accelerator pedal assembly. Install the mounting bolt on the accelerator pedal assembly.
Align the stud on the floor with the threaded hole and insert the accelerator pedal limiter until it touches the end surface.
Post-installation check
Make sure the accelerator pedal moves smoothly throughout its entire travel.
Make sure the accelerator pedal returns to its original position securely.
For operations to check the electrical part of the accelerator pedal position sensor, see chapter Engine management system.
If the connector is disconnected from the accelerator pedal, perform "Accelerator pedal release position learning procedure".