Roof molding
Fastening the roof molding
Note: Other moldings are replaced in a similar manner.
1. Use a plastic wedge to lift the rear edge of the roof molding, remove the retainer and cut the double-sided adhesive tape securing the molding.
2. Remove any remaining adhesive tape from the molding and body.
3. Clean the mating surfaces of the roof and molding.
4. Glue the retainer on the body side and wait at least 40 minutes.
5. Apply primer (for example Sumitomo 3M N₂00) on the rear surface of the retainer mating with the adhesive tape from the body side.
6. Apply adhesive tape to the back of the retainer on the body side
7. Align the front side of the roof molding with the windshield seal, press the roof molding from front to back and secure it to the body using double-sided tape and fasteners.
Windshield seal
1. Remove the windshield fairing (see section Removal and installation the windshield fairing).
2. Remove the covers from the wings by cutting the double-sided adhesive tape.
3. Apply protective tape around the perimeter of the windshield seal and cut the seal lip.
4. Remove any remaining seal.
5. Apply primer and glue.
6. Align the white mark on the new windshield seal with the mark on the spacer at the top of the windshield.
7. Press the seal with your hands until its lower barb engages the glass, then press the seal outward.
8. Remove the protective tape and install the fender covers and windshield fairing.
Side door glass seals
Fasteners for side door glass seals
1. Lower the door glass completely.
2. Grasp the seal and pull it upwards, releasing it from the clips (starting from the back).
3. Installation is carried out in reverse order.