2. Start the engine. Warm up the engine at idle speed to normal operating temperature.
3. Turn off the engine and wait 10 minutes for the oil to drain into the engine sump.
4. Raise the car with a garage jack and support it with safety stands.
Place safety stands under the car jack mounting points
5. Place a container to collect the oil under the drain hole.
6. Open the hood.
7. Remove the filler cap.
8. Using a wrench, unscrew the drain plug and drain the oil completely.
Data posted on the website (NissanBook)
If the oil filter needs to be replaced, unscrew it and install a new filter
|
Engine CR14DE
 |
Engine HR16DE
 |
9. Clean and reinstall the drain plug with a new sealing washer. Use a wrench to tighten the plug securely.
Do not tighten the drain plug beyond the torque specified below.
Tightening torque of the drain plug; 29-39 Nm (3-4 kgf·m).
10. Fill the engine with the required amount of oil of the recommended grade.
The filling capacity of the engine lubrication system is indicated in the section "Technical information".
11. Screw the filler cap back on.
12. Start the engine.
13. Check the tightness of the drain plug. Tighten if necessary.
14. Turn off the engine and wait 10 minutes.
15. Check the engine oil level again. Top up if necessary.
16. Lower the vehicle.
17. Close the hood.