Removing
1. Remove the wheels from the car.
2. Remove the lock plate.
3. Remove the cap and unscrew the fastening nut from the upper side of the stabilizer strut, then disconnect the stabilizer strut from the suspension strut.
4. Disconnect the steering knuckle from the suspension strut.
5. Loosen the suspension strut mounting insulator bolts and remove the strut assembly.
Installation
Installation is made in an order, the return to removal.
Note. Make sure the identification label (A) on the mounting insulator, the suspension bracket is placed as shown in the figure.
The arrow in the figure points to the front of the car.
Note. Perform final tightening of bolts and nuts at the attachment point (rubber bushing) on an unladen vehicle with wheels on the ground.
Check after installation
1. Check wheel alignment.
2. Adjust the neutral position of the steering angle sensor.