Removing
1. Remove the wheels from the car.
2. Remove the engine protection tray from the vehicle.
3. Remove the front suspension subframe struts from the vehicle.
4. Remove the wheel speed sensors from the steering knuckles.
5. Disconnect the upper parts of the stabilizer struts from the front suspension struts.
6. Disconnect the outer steering joints from the steering knuckles.
7. Disconnect the intermediate shaft from the steering gear.
8. Disconnect the transverse levers from the steering knuckles.
9. Remove rear engine tie rod.
10. Place a suitable jack under the front suspension subframe.
11. To turn away bolts and nuts of fastening of a subframe of a forward suspension bracket.
12. Gradually lowering the jack, remove the front suspension assembly from the vehicle.
Attention. When removing, fix the suspension properly on a suitable jack.
13. Remove the mounting bolts and nuts, then remove the transverse levers and stabilizer bar from the front suspension subframe.
Installation
Installation is made in an order, the return to removal.
Note. Perform final tightening of bolts and nuts at the fixing point (rubber bushing) but an unloaded car with wheels on the ground.