Removing
1. Remove the rear wheels from the vehicle.
2. Remove the center console.
3. Disconnect the parking brake switch wire connector.
4. Unscrew the adjusting nut and loosen the front cable.
5. Remove the parking brake lever assembly.
6. Remove heat shield and center muffler.
7. Disconnect the front cable from the rear cables and remove from the vehicle.
8. Remove the parking brake pads and disconnect the rear cables from the crank arm.
9. To turn away bolts of fastening of back driving cables of a parking brake then to remove back cables from the car.
Installation
Installation is made in an order, the return to removal.
Attention. If the adjusting nut is removed, do not reuse it.
Note. After installation, adjust the travel of the parking brake lever.