Removing
Note: When reconnecting the coiled wire, fix the wire with tape so that the fixed body and the moving part are aligned. This saves you the hassle of performing the neutral check procedure when installing the coiled wire.
1. Set the front wheels to straight ahead.
2. Remove the driver's airbag module.
3. Loosen the steering wheel locknut after the steering column is locked.
4. Remove the steering wheel with a puller (special tool: ST27180001).
Installation
Installation is carried out in the reverse order of removal, taking into account the following:
Note: Make sure the coiled wire is in the neutral position. Neutral position is determined by turning 2.6 turns to the left from the right end position to the locating pin (1) above.
Caution: Do not overtighten the coiled wire unnecessarily. And don't turn it any more than necessary (wire may break).