Removing
Attention: Before separating the gearbox from the engine, remove the crankshaft angle sensor from it (POS). Be careful not to damage the edge of the sensor.
1. Remove the battery.
2. Remove the air cleaner. See chapter Mechanical part of the engine.
3. Disconnect the ball end of the gear selection cable and the end of the gear change cable. See section «Gearbox control linkage».
4. Disconnect the clutch tube.
5. Remove a collar of an electroconducting of the engine.
6. Remove the starter. See chapter electrical equipment.
7. Turn out an adjusting bolt from the left support of the engine. See chapter Mechanical part of the engine.
8. Attach the motor hanger.
9. Lift the car and remove protective slips from forward right and left wings.
10. Remove the engine protection from the bottom.
11. Remove the front exhaust pipe. See chapter Accelerator, fuel system and exhaust system.
12. Remove the turbocharger outlet pipe bracket from the transmission.
13. Remove the right and left drive shafts. See chapter Front axle and suspension.
14. Disconnect the ground cable from the gearbox.
15. Support the gearbox with a telescopic stand.
16. Remove an arm of a back support of the engine. Then remove the rear torque rod from the gearbox.
Caution: Do not remove the rear torque rod from the suspension beam.
17. Remove an arm of the left support of the engine.
18. Disconnect the connector from the position switch at the gears.
Installation
Installation is carried out in the reverse order of removal.