Removing
1. Remove cardan shaft.
2. Align the final drive flange and the threaded end of the ATC coupling and mark.
Attention: Apply paint alignment marks. Do not scratch the surface.
3. Using the special tool, unscrew the nuts from the flange.
4. Remove the oil seal using a screwdriver or similar tool.
Installation
1. Apply Nissan MP No. 2 special grease to the lips of the oil seal. Press in the seal with a punch (special tool), as it shown on the picture.
Attention:
When pressing in, do not distort the gland.
Do not reuse seals, replace them with new ones.
2. Align the marks made before removal on the main gear flange and the threaded end of the ATC coupling.
3. Screw the nuts onto the flange and tighten to the required torque using the special tool.
: 100-122 N-m (10.1-12.5 kg m)
4. Install the cardan shaft.