Removing
1. Remove the following components:
- protective pad from the front right fender;
- drive belts; see section «Drive belts»;
- crankshaft pulley; see section «Valve train chain».
2. Remove the front oil seal using a screwdriver.
Attention: Do not damage the front cover or crankshaft.
Installation
1. Apply fresh engine oil to the new front oil seal and lip.
2. Using a suitable drift (1) press in the front oil seal so that it is flush with the mounting surface.
Suitable drift: outer diameter 50 mm, inner diameter 44 mm.
Attention:
- Do not damage the front cover or crankshaft.
- Press in at a right angle, avoid burr formation and distortion of the stuffing box.
The installation direction of the front oil seal is shown in the figure.
3. After this operation, installation is carried out in the reverse order of removal.